What real effect does the constitutional order of Business have on legislation quizlet?

The legislative process on the Senate floor is governed by a set of standing rules, a body of precedents created by rulings of presiding officers or by votes of the Senate, a variety of established and customary practices, and ad hoc arrangements the Senate makes to meet specific parliamentary and political circumstances. A knowledge of the Senate's formal rules is not sufficient to understand Senate procedure, and Senate practices cannot be understood without knowing the rules to which the practices relate.

United States Senate Committee on Rules and Administration

The Senate Rules Committee has jurisdiction over the internal management of the Senate, as well as responsibility for legislation establishing federal election laws.


Rules

Standing Rules of the Senate

Senate Manual (GPO-govInfo)


Procedure

The legislative process on the Senate floor is a balance between the rights guaranteed to senators under the standing rules and the need for senators to forgo some of these rights in order to expedite business.

Riddick’s Senate Procedure (GPO-govInfo) |  Search   Riddick's Senate Procedure (GPO)

The Legislative Process on the Senate Floor:  An Introduction (CRS) (PDF)

Flow of Business:  Typical Day on the Senate Floor (CRS) (PDF)

The Amending Process in the Senate (CRS) (PDF)

House and Senate Rules of Procedure:  A Comparison (CRS) (PDF)


The Parliamentarian

The Senate and the House each has an Office of the Parliamentarian to provide expert advice and assistance on questions relating to the meaning and application of that chamber's legislative rules, precedents, and practices. In the Senate, staff from the parliamentarian's office sit on the Senate dais and advise the presiding officer on the conduct of Senate business.

The Office of the Parliamentarian in the House and Senate (CRS) (PDF)

Floyd M. Riddick, Senate Parliamentarian (1964-1974), Oral History Interviews

First Official Parliamentarian, July 1, 1935


Quorum

Article I, section 5 of the Constitution requires that a quorum (51 senators) be present for the Senate to conduct business. Often, fewer than 51 senators are present on the floor, but the Senate presumes a quorum unless a roll call vote or quorum call suggests otherwise.

Compulsory Attendance, June 25, 1798

Quorum Busting, October 1893

Voting and Quorum Procedures in the Senate (CRS) (PDF)


History of Senate Rules

Learn about the history of Senate rules with these essays by the Senate Historical Office.

Getting Together, Joint Rules of the House and Senate, April 15, 1789


House Rules and Procedure

The standing rules of the House govern the daily order of business on the House floor by making certain matters and actions privileged for consideration. House decisions to grant other individual bills privileged access to the floor, usually upon recommendations from the House Rules Committee , also determine the daily order of House floor business.

Rules of the House of Representatives

Deschler’s Precedents (GPO-govInfo)

House Rules and Manual (GPO-govInfo)

The Legislative Process on the House Floor:  An Introduction (CRS) (PDF)

The Amending Process in the House (CRS) (PDF; long)


Related Items

Interested in related materials? Take a look at these Virtual Reference Desk subjects and other links for more information.

Cloture

Filibuster

Legislation and Records

Votes


 

Step 1: How Your Idea Becomes A Bill

All legislation starts off as an idea. These ideas can come from anybody and the process begins when either an individual or group persuades a Member of the Legislature to author a bill. The Member then sends the idea and the language for the bill to the Legislative Counsel's Office, where it is drafted into the actual bill. The drafted bill is returned to the legislator for his or her review. Persons or groups that originated the idea for the bill may also review it to ensure that the provisions they desire are in the bill in the correct form. If the author is a Senator, the bill is introduced at the Senate Desk; if an Assemblymember, at the Assembly Desk, where it is assigned a number and read for the first time.

Step 2: What To Do When Your Bill Goes To Policy Committee

The bill then goes to the Senate or Assembly Rules Committee, where it is assigned to a policy committee. You can find out where your bill is assigned by calling the author. Since bills are not heard in policy committee until 30 days after they have been introduced and printed, there is plenty of time to investigate a bill or contact your legislator to communicate your position on the bill.

 

Each bill must appear in the Daily File for four days prior to being heard in a committee. The Daily File is the agenda of the day's business, together with public notice of bills set for committee hearings. By checking the File, you can keep track of bills that are being scheduled for committee. If you live out of town and plan to testify at the hearing, it is a good idea to call the author or your legislator to make sure that the bill is going to be heard on that date. Sometimes bills are taken off the agenda at the last moment.

At this point, the role of the District Office should be emphasized. District Office staff are there to serve the needs of constituents. They can be extremely helpful in making contacts and getting information from Sacramento.

It is a good idea to schedule a meeting with your legislator while he or she is in the district. Communicate your concerns regarding legislation. Indicate that you want to work with the Member's office on a particular issue.

Most bills generate support and opposition from a variety of groups. Find out who these groups or individuals are by calling the author's office where lists of the letters and phone calls received on each bill are kept. A good strategy is to align yourself with the groups that hold your position and work together to talk to the members of the committee BEFORE the bill is heard. Keep your letters and discussions with the legislators short and to the point.

When testifying before the committee, first state your name and the organization that you represent or indicate that you are a concerned citizen and state where you live. The Members of the committee will be interested to hear what you have to say and usually do not grill individual citizens who testify in the same way that they do lobbyists. Keep your testimony short and to the point.

Step 3: What If Your Bill Goes To A Fiscal Committee?

If the bill has a fiscal impact or a state cost, it will be heard in either the Senate or Assembly Appropriations Committee. At this point, you should inform the Members of the committee why you support or oppose the bill based on a fiscal argument. The finance committees are concerned about fiscal impact and not policy considerations.

Try to see the staff analysis that has been done on the bill by the policy committee, the Department of Finance, and/or the Legislative Analyst. Members of the fiscal committees read these analyses before they vote. These analyses are available on the Internet.

If you believe that the numbers or the fiscal impact of the bill are not correct as reported in these analyses, you should prepare your written comments before the committee meets. Your written material should be available to pass out to the committee Members at the hearing where you present your testimony.

After the bill passes the fiscal committee, it is read for the second time on the Floor.

Step 4: After Your Bill Passes The House Of Origin And Goes To The Second House

Third Reading is the last stage that a bill goes through in the house of origin before it passes to the second house to go through the committee process all over again. On Third Reading, the author presents the bill for passage by the entire house. Most bills require a majority vote (it must pass by 21 votes in the Senate and 41 votes in the Assembly), while urgency measures and appropriation bills require a two-thirds vote (27 in the Senate, 54 in the Assembly).

 

At any time during the legislative process the bill may be amended, either in committee or on the Floor. After the amendments have been submitted to the author, the bill goes to another printing to reflect the changes that have been made. The Senate or Assembly History records the dates when a bill has been amended. Amendments can be substantial or technical and may affect your position on the bill.

Amendments should be followed very carefully. Contact with the District Office can be helpful in keeping track of current versions of a bill. If you subscribe to the bill, these amendments will automatically be sent to you. If you change your position on a bill due to a favorable or unfavorable amendment, you should inform the author and your legislator.

If a Senate bill is amended by the Assembly, or vice versa, and the house of origin refuses to concur in those amendments, the bill will go to a conference committee. If the house of origin does concur, the bill goes to the Governor.

Members of the conference committee are appointed by the Rules Committees; three members from the Senate and three from the Assembly meet to negotiate out the differences. If they agree on a single version, it goes back to both Floors for approval.

Communicate to your legislator or the author which amendments you prefer and why. The conference committee meetings, particularly at the end of the two-year legislative session, are scheduled quickly and can be easily missed. You must stay in close contact with the author's staff to stay on top of fast-breaking developments. It is also important to know who will be serving on the conference committee so you can inform them of your position.

Step 5: You Can Still Act After Your Bill Goes To The Governor

The Governor has 12 days to sign, approve without signing, or veto a bill. A letter or phone call to the Governor's Office is appropriate to state your position on the bill.

 

If the bill is signed or approved without a signature, it goes to the Secretary of State to be chaptered. If the Governor vetoes the bill, a two-thirds vote in each house is needed to override the veto. The Governor's Office releases veto messages which explain the veto; these messages are available from the Governor's Office and on the Internet.

A wealth of legislative information is now available on the Internet. You can get bills, amendments, staff analyses, committee agendas, and other legislative information, plus a simple way to track legislation.

Related Links

Information to help follow the process

Glossary of Legislative Terms

How do interest groups interact with other actors in the legislative process quizlet?

Interest groups interact with others in the legislative process by providing information and support to legislators and their staff.

Which of the following accurately describes how a bill is formally introduced in the Texas Legislature?

To introduce a bill, a legislator must file the bill with the chief clerk of the house or the secretary of the senate, as appropriate. Both the house and senate rules permit unrestricted introduction of bills during the first 60 calendar days of a regular session.

What is the term for the process of making substantive changes and editorial corrections to a bill?

amendment. A change to a bill. Committees often consider amendments to bills (through a process called "mark up"), and members may also offer amendments on the House or Senate floor, if permitted by the rules.

What are the steps of the legislative process?

The legislative process in a nutshell:.
First, a Representative sponsors a bill..
The bill is then assigned to a committee for study..
If released by the committee, the bill is put on a calendar to be voted on, debated or amended..
If the bill passes by simple majority (218 of 435), the bill moves to the Senate..

Toplist

Neuester Beitrag

Stichworte